Avocado Bucket MKII - Fixed

Remixed version of this design which removes the weird seam on one side, that's all.

To improve buoyancy, you could vary the infill density as follows (works on PrusaSlicer and SuperSlicer, but I'm sure it will work on other slicers as well):

• add a height range modifier, from 0mm to 4.4mm. The printer will put some horizontal infill/bridging layers on top of this printed section.
• set the infill percentage for the 0-4.4mm range to be something like 15%, to avoid printing the horizontal layers mid air
• set the overall infill percentage to 0%. This will result in a hollow print after the 4.4mm mark

This should remove some weight from the object, useful if you are going to put large seeds in it.

Printing with filaments that don't absorve water is preferable, like PETG.

Category: Outdoor & Garden