Rolling Pin Hanger

I was looking for a way to clean up clutter in the kitchen cabinets. I have two rolling pins and they kept getting in the way. Either they were on top of boxes or under them and to make maters worse, they were always stored in those upper cabinets above the refrigerator. I came up with this hanger to hold one or two rolling pins and it mounts to the inside of the cabinet (must be a deeper cabinet, not 12")

I designed a single and a double hanger. The cross piece helps keep them aligned and makes it easier to mount on the inside of the cabinet (or on a wall if you choose). Used #6 screws to mount to the wall.

IF MOUNTING TO THE INSIDE OF THE CABINET, BE SURE TO USE THE RIGHT LENGTH SCREWS AND BE CARE YOU DON'T DRILL THROUGH THE OUTSIDE WALL OF THE CABINET

For a double hanger, you need to print two of the double end pieces and two of the cross pieces.
For a single hanger, you need to print two of the single end pieces and one cross pieces.

The cross piece snaps right in, depending on your printer tolerances, you might need to sand the cross piece a bit to make it fit flush.

Print instructions

Category: Kitchen & Dining Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Resolution: .15 or .2

Infill: Grid 20%

Filament: Hatchbox PLA Grey
Notes:

You can print this in .15 or .2 layer height.