PCB mount for Hydra hot end

Made to work with the Hydra hot end. I made it to allow for serviceable hot end like what is on the Bambu printers.

It work with this hot end: https://www.printables.com/model/169197-hydra-fan-duct-tool-change-system-for-ender-3-ende

there is a good bit of modification necessary for this to work. the harness going to the hot end had all all of the ends at the nozzle cut off and soldered to a small pice of prototype board.  

I used these connectors for the protoboard: https://www.amazon.com/dp/B08G188ZQ8?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

these are the same connectors that most fans are compatible with as well as the factory babmulabs x1c ceramic heater. the thermistor is not compatible with these but it is easy to solder on the connector to the thermistor. 

Installs onto pf the direct drive bracket