Raspberry Pi 2/3 Micro NAS or Media Center

I wanted a really small box for my raspberry pi that also fitted in a hard drive. I browse around thingiverse and the ones I saw had exposed wires, didn't fit on my print bed etc. etc.

So this variation:

• Fits a raspberry pi 2 or 3
• Exposes the HDMI, Audio and Power plugs to the outside world
• Fits a seagate portable drive
• Has no exposed wires
• Prints on a 120mm square print bed

The only thing that isn't exposed is the Ethernet or USB ports. I couldn't think of a nice way to do this, so it's up to you to make your own hole in one of the end-caps.

You need:

• 8x M3x15 bolts
• 8x M3 Nuts
• 4x M3x5 Bolts
• Raspberry Pi 2 or 3
• Seagate portable hard drive
• 15cm USB cable

I had already drilled out my Pi's mounting holes to 3mm. Seriously, just do this. It skips fussing around with M2.5's. The Pi is mounted by screwing short M3's into the plastic. See the pictures for how it is assembled

There's no cooling provisions because the Pi2 I'm using doesn't get that hot, and the drive doesn't generate that much heat.

Print Settings

Printer:

Snapmaker

Rafts:

Supports:

No

Resolution:

Filament: Flashforge PLA Blue

Category: Electronics