Drone Back Up Camera for 32mm Standoffs with 120Degrees of Movement

I recommend printing the one file given or use supports. This model REQUIRES plastic coated wires for their stiffness. Silicone wires are to pliable and don't preform well.  Install servo, turn on servo and go to max and install the gear at it's max position. Then install camera housing at a max position. NOTE: there is 180degrees of movement but servos will only apply 120. There Max camera tilt can be adjusted slightly.  Wires must overlap in a circle within the servo lid as shown

Pull the wires into a tight circle to install lid. Assure they are not pinched and have full movement when camera is fully rotated in both directions.  NOTE: Servos vary and might require shimming and/or gear realignment.  Mounting holes are for standoffs 32mm to center. For cameras with upper wire plugs or lower wire plugs. As shown with the "Arris Cat" camera.