May 5, 2026
Description
This model was invented alongside another project, but I've been thinking about such a chain for a long time. I managed to print it for the first time.
This print will test the adhesion of the filament to printing plate, since the contact area is small and the bridges during printing
No supports !!!
The size of one link of the chain is 20x12x4.4mm.
When reducing, the contact area decreases, when increasing, the bridges lengthen. Try to test the limits of your printer !!
For a good result, I recommend printing on a smooth printing plate, and gently roughen the surface with scotchbrite and clean with Isopropyl. A bath with detergent will also help a lot, because the plate gets greasy from frequent hand contact!!!
This way you can print without brim!
https://www.printables.com/model/1617970-chain-fully-print-in-place
License:
Creative Commons — Attribution — Noncommercial — NoDerivatives
Thorin Oakenshield
