April 3, 2022
Description
A set of holds with the same silhouette on the wall but vastly different positivities from #1 having effectively nothing, bad even for a foot or screw-on to #5 being usable on a 30 degree wall for a V4 climber.
These are designed to have the texturing process outlined here https://www.youtube.com/watch?v=9TW4BkhRIjw used on them. You'll need 5mm ID 10mm OD stainless washers for the holes. Print with fuzzy skin on the outside (PrusaSlicer and Cura both have these)
Disclaimer: These designs are provided as-is. I make no claim they will produce safe holds. I am not qualified to certify holds, let alone designs of holds safe. Do not attempt to produce climbing holds unless you can take reasonable safety measures and take responsibility for your own safety.
UNLESS OTHERWISE MUTUALLY AGREED TO BY THE PARTIES IN WRITING, LICENSOR OFFERS THE WORK AS-IS AND MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND CONCERNING THE WORK, EXPRESS, IMPLIED, STATUTORY OR OTHERWISE, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF TITLE, MERCHANTIBILITY, FITNESS FOR A PARTICULAR PURPOSE, NONINFRINGEMENT, OR THE ABSENCE OF LATENT OR OTHER DEFECTS, ACCURACY, OR THE PRESENCE OF ABSENCE OF ERRORS, WHETHER OR NOT DISCOVERABLE. SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OF IMPLIED WARRANTIES, SO SUCH EXCLUSION MAY NOT APPLY TO YOU.
Printer:
Artillery Sidewinder X1
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
100%
Filament:
ecoPLA Tough Tough PLABlack
Notes:
I printed at 0.2 with infill every 2 layers which produced a much faster print but with good surface. I also printed with fuzzy skin, which significantly improves bonding between the resin and the print.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
11
Giles Barton-Owen
