December 1, 2022
Description
12/1/22-Updated to v3. Only a slight change. Fixed the small holes that was found by user Jason Wu.
4/19/22-Updated the model to v2. This version has more clearance between the hot end and the shroud.
This was printed in PLA+; I have had a similar Satsansa running on my Ender 3 that was printed with PLA and I've noticed no deformation on it.
The bridge test shows before and after the satsana was installed. There is significant improvement in the bridging.
Used x3 m3x12 bolts to secure it.
Printed at a layer height of .2
Supports are needed just for the three over hangs on the back of the print.
License:
Creative Commons — Attribution
7
3dprint
