Capra Audio Cup Holders for Audio-Technica ATH-A700 Headphones

I love my Audio-Technica ATH-A700, but it's on its last legs, the plastic was basically disintegrating, but the drivers and closed back housing are still in good condition. I remixed the cup holders from the “Audio Technia Capra Headband Conversion” to fit the drivers and closed back housing. Follow the same instructions from "Audio Technia Capra Headband Conversion". This modification requires a soldering iron.

BOM

• 2x (adjustment-arm.stl + pivot-block.stl) or adjustment-armstatic.stl from "Capra Headband V3"

• 1x comfort-strap-capra-headband-v3.stl from "Capra Headband V3"

• 1x Any of the TPU-Bands, I used the tpu-band-smooth.stl from "Capra Headband V3"

• 1x yoke-l.stl (below) or from "Audio Technia Capra Headband Conversion"

• 1x yoke-r.stl (below), this is mirrored from yoke-l.stl

• 1x Left Cup Holder from this model

• 1x Right Cup Holder from this model

• Original closed back housings from Audio-Technica ATH-A700 from both sides

• Original drivers from Audio-Technica ATH-A700 from both sides

• Original earpads or aftermarket from Audio-Technica ATH-A700

• M3 Heat-set inserts

• M3 FHSC Screws

• 3.5mm Connectors

• Wires 

• 3.5mm dual entry headphone cable