March 7, 2026
Description
Uses two parts with clips that slide into each other.
One part goes on the dock and utilizes the two M4 mounting holes.
The other part is screwed into the desk and uses any small wood/sheet screw (I use 2.5x10 screws).
Both parts should be printed with the larger section facing the bed.
2*M4x12 cap head bolt (for the dock)
4*small wood screws for the desk (2.5-3.5mm in diameter), preferably pan head
The counterbore allows for screw heads up to 6.8mm in diameter
Post-processing
The screw counterbores have a solid layer for bridging. You can either remove it with a drill or probably push the screw through directly.
It can be mounted only for front or back sliding.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
sicarius80
