Reversed Mounting Legs for mounting Ultimulti MMU3 to floor of the Coreboxx

This model utilizes the MMU floor mount designed by @MIRE (Collection of mods for coreboxx premium)

V2 is ready and I'm much happier with it.  It raises the MMU 30mm over the V1 to give the out PTFE a better angle to the slot in the coreboxx.  It also gives some clearance from the bottom to allow for my active rewinder motherboard.

Print instructions

Before you start printing G-codes or individual parts, read the notes below each file.

Download the latest PrusaSlicer and use the following settings*:

• Print settings: 0.20mm STRUCTURAL

• Filament: PETG (tested on Prusament)

• 15% Gyroid infill

* Note that print settings are recommended, but you can experiment with your own.