April 8, 2022
Description
This is a printable replacement rear fender for the carbon scooter which is sold under many many different brands, here are just some of them:
An additional M2x40 with 2 washers and a nut is needed to be inserted in the hole. This gives additional stability around the mount of the fender since layer adhesion was not sufficient.
After printing the metal part from the original fender should be installed. I have not yet added these holes to model so currently these need to be done manually. Use the original screws.
Tip: Get the scooter cheap on AliExpress for below 300 dollars.
Printer:
Prusa i3 mk2
Rafts:
No
Supports:
Yes
Resolution:
0.15mm layer at 60mm/s
Infill:
100%
Notes:
Print laying on its side.
License:
Creative Commons — Attribution — Noncommercial
11
chixxi
