1x1 half height vase mode gridfinity bin

I wanted to have some stackable screw storage bins for the Gridfinity modular drawer system that printed in vase mode. The ones I found were taller than I would like so I made this little half height one! It features a slanted wall on one side to make it easier to grab small screws out of it. 

Printing:

I printed mine with a .6 nozzle in vase mode. If you intend to do the same you'll need to use at most a .24mm layer height or less because otherwise it will make gaps in the slanted wall and probably not be very strong. PLA is fine for these.