March 27, 2026
Description
This is a fully 3D printable push stick adapter for the Scoot & Ride Highwaykick 1, designed to allow the use of a 22–23 mm diameter broom stick as a push handle when the scooter is in seated mode.
The Highwaykick 1 cannot normally be retrofitted with a push bar, so this adapter provides a simple and effective solution for parents who want to assist or guide their child.
The design is completely tool-free and requires no glue, no supports, and no additional hardware.
The adapter body is printed in two halves, aligned using square guide rods, and secured with hand-tightened nuts. A built-in print-in-place spring clip (similar to a tent pole clip) locks the stick securely in place.
Designed for Scoot & Ride Highwaykick 1
Fits 22–23 mm diameter sticks (standard broom handles)
Enables push-handle functionality in seated mode
Fully 3D printable
No supports required
Print-in-place spring clip
Tool-free assembly (hand-tightened nuts)
No glue needed
Easy to assemble and remove
Print both body halves and hardware components
No supports required
Ensure good layer adhesion for structural strength
Clean any minor imperfections around the clip mechanism
Material: PETG or ASA recommended (for strength and outdoor use)
Infill: 30–40%
Perimeter: Min 2.4mm
Supports: Not required
Insert the square alignment rods into one half
Place the second half on top
Insert and tighten the two printed nuts by hand
thread the broom stick until its fixed properly
Stick diameter should be within 22–23 mm for best fit
Fit may vary depending on printer tolerances
Designed for use in seated configuration only
This is a DIY accessory. Always supervise children during use. Muffelkraft assumes no responsibility for improper installation or misuse.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Muffelkraft
