FPV / Pixhawk / Ardupilot 3d Model Accessories for AOS UL10 Cine

In PLA. Print 15% infill with support on the build plate and organic supports. .20 balanced or structural.

In PC Blend. Print 15% infill with support on the build plate and organic supports. .20 structural.

Brace and Lock - Keeps the arms from falling off the frame when the top plate is removed for maintenance.

1. Place the Brace shown in blue between the truss so that the standoffs can keep the arm from falling off the bottom part of the frame as depicted in the photos

2. Place the Lock over the top and push it down until its bottom is flush with the bottom plate.

RFD900x Mount.

1. Use a 10mm M3 screw and push it from the single hole between the SMA connectors on the enclosure down and through the point of the triangle. 

2. Fasten using a M3 nut. 

3. Hook the mount to the open rectangular opening on the bottom frame plate.

4. Line up the rear holes (Aft 30x30 mounting holes on the frame) and Fasten the two holes on the Modem enclosure using 10mm M3 screws and M3 nuts.