Duotone Entity Strap Buckle

I've tested some sessions. It works, it didn't break, but I injured my foot when I landed hard from a jump. XL too high. But if you don't do jumps or can land smoothly, then it's ok.

⚙ Recommended Print Settings

• Layer height: 0.16 mm

• Walls  3

• Infill: 100%

• Material: Whatever you think works better, I did PLA. Haven't tested durability yet.

• Supports: yes if you print on the side. Possibility to cut in half and glue together later. I don't think it will be strong when printing in an upright position.