towel rack bracket

for mounting with tesa adhesive screws 2.5kg (77902-00002-00)

there is 8cm between the wall to the center of the rod.

I have uploaded two variants, Ø15mm and Ø20mm to deliver a more flush look for the Räcka curtain rod that i intended to use for this project.

the print is assymetrical and will need a mirrored partner.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2mm

Infill:

Filament: devil design pla natural

Notes:

Post-Printing =============

Due to printing with support on the upper overhang i went through the cavity with a stubby knife to ensure good fitment between the anchor and the part.

How I Designed This

I wanted to print a strong bracket with more flair than just a wedge against the wall. To add strength in the direction of the adhesive anchor to the rod and back down to the bottom of the print i added in triangular support structures, this was also done to minimize the amount of material used on the print.

Category: Bathroom