Easter Eggs with filament

Eggs with spiral holes for 1,75 filament
For 3mm resize the model to 171-172%

Even pure model can be used as a decoration but combined with some nice color filament it will look better :)
Cut filament to 10,5cm each (4.13inch), or little more (you need 10,3cm but it's better to cut off the rest later)

Pliers or some flat metal may be used to push filament in the hole.
I started from the top, pushed the end in with pliers and then pushing it all the way down. May not be very easy, depends on filament used and prints options.

IMPORTANT

• TPU is the easiest to use for this
• for PET-G (on photos) or similar flexibility filament you may need pliers to bend both ends.
• PLA can be used too (I did it on prototypes) but it may break unless you will heat it up a little - be carefull to not overheat the egg (it will deform) OR cut smaller pieces like 6-7cm instead of 10,5cm and use it in the center only (where we have smaller angles)

---

No infill needed
2 walls should be good

With transparent filament you can get a nice result with darker edges when using more top/bottom layers than walls.
For more clear result use the same numbers on both(for white egg I used 3 walls/top/bottom)