April 9, 2026
Description
Designed this model as a display stand for my magnetic SLS model.
I was able to print all the components upright without supports on my Ender 3 (results may vary).
Glue is necessary to connect all the pieces together, but the connectors will help with alignment.
(you may be able to try scaling up the connector piece by 1% to make it a press fit)
What to print:
4x Launch Tower Connector
3x Launch Tower Section
1x Launch Tower Base
1x Launch Tower Platform
Tip: Use up the last bits/scrap of filament for the connector pieces.
License:
Creative Commons — Attribution — Noncommercial
TotallyRidiculous
