Prusament Spool RC Car Stand (Rotating)

Why spend lots of money on a fancy RC car stand? You can print one AND reuse a Prusament spool! This model is optimized to have no supports and print easily, so you don't have to deal with print troubles and support material (which we all know is sometimes a pain to remove, and uses up filament).

There are no specific print instructions, so you can print it with any material, layer height, or infill. Assembly is easy; you have to disassemble a Prusament Spool first, then put the base piece onto the spool side. Then for the rest, you can refer to the exploded view below. You may have to use glue for the turntable and uprights, as well as the base and pivot. Also, print to of the "PSRCCS Upright.stl" pieces (the green pieces shown below.

There are four heights of pivot: 30, 40, 50, and 60 millimeter. Pick the one that suites your needs.

NOTE:

Do not glue the pivot to the turntable (the dark blue and dark grey pieces shown below) so it can still rotate!

Happy printing!

If you print this, feel free to create a Make of it!