Musical note headphone holder

This is a headphones holder shaped as a musical note.

The rod is a 12mm diameter aluminum pipe. If you want to match colors you can easily print a shaft by generating a 12mm cylinder right in the slicer. if you do so, I recommend printing flat and plane cutting a couple mm from the bottom so it prints nice without supports (the flat side will go facing the back). 

There are two sizes, calling for a 190 mm or 230 mm rod respectively. The short one is ok for my daughter's headphones (actually adult size, but kept on the shortest headband length). If you have large headphones or keep the headband extended, you should consider the taller version.

The printed parts change between versions because the angle is adjusted to keep the two parts aligned. If you use a longer or shorter rod than the intended 190 and 230 mm, it will still work, but the flag will move slightly left or right, you may not even notice, or it may sit in the back of your head and keep you awake :)

The head exists in two flavors too, with or without a slot for resting a cellphone/MP3, and the related channels for cable management.