Dyson V10/V8/V7 Accessory Mount/Holder V2

This is a remix of an earlier design: https://www.thingiverse.com/thing:3408661

In this remix I have:

1. Value Engineered thing components to reduce the print time and plastic usage.
2. Redesigned assembly with all clip fits so the bolts, nuts & washer are no longer required.

Printing\Assembly Instructions:

1.The components are quite robust so multi perimeters are not absolutely essential. All nodes prototypes were printed in PLA with a 25% infill and 2 perimeters. The bridging collar was printed with 4 perimeters and 30% infill.

2.All parts can be printed without support but the Connection Collar may require a raft for stability depending on build surface (all my prototype parts were printed successfully without any rafts). I have integrated support for the top clip in the Bridging Collar to produce a better finish and reduce stringing. Both of these supports will need to be removed prior to assembly (see uploaded image).

2.Printed at 0.2 resolution on an Ender 5 & CR10S.

3.The Retention clip was printed in PLA but even greater flexing may be achieved with PETG.

In my prototype testing, this thing works has perceived, strong & resilient and is very much fit for purpose. However, if you think that your Dyson equipment may be handled very roughly I would recommend making the previous version which is slightly over-engineered and very solid.

Update: 22\02\19

Re uploaded thing files with both Binary and ASCII versions

Update: 22\02\19

Uploaded versions of thing files inspected in Meshmixer

Category: Organization