Clip-On Pond Fountain Statue (10mm Tube Compatible)

Clip-On Pond Fountain Statue (10mm Tube Compatible)

Add a subtle, classical touch to your pond with this clip-on fountain statue. Designed to integrate cleanly with small backyard ponds, this piece transforms a simple pump setup into an elegant flowing water feature.

Overview

This statue is designed to route a 10mm water tube through the figure, creating a gentle pouring effect from the vessel. The result is a quiet, continuous stream that adds movement, sound, and visual interest to your pond.

The statue mounts securely to the pond edge using a ratcheting clip system, allowing for quick installation, adjustment, and removal—no tools required.

Key Features

• 10mm Tube Pass-Through

  • Internal channel designed for standard 10mm pump tubing

  • Clean water exit integrated into the statue’s vessel

• Adjustable Ratchet Clip Mount

  • Securely attaches to pond walls

  • One-handed adjustment with locking teeth for different wall thicknesses

  • Keeps the statue stable even with continuous water flow

• Modular Design

  • Statue and clip are separate components

  • Easy to print, assemble, and replace parts if needed

• Low-Profile Water Feature

  • Designed for small pumps and low flow rates

  • Ideal for container ponds, patio ponds, and wildlife water setups

Pond Compatibility

This model was designed around a pond wall profile with the following approximate geometry:

• Outer lip width: ~35.9 mm

• Inner step width: ~25.15 mm

• Wall height engagement: ~17.1 mm

• Material thickness (clip contact): ~3 mm

This closely matches many injection-molded plastic garden ponds with a rolled or stepped rim.

✔ Guaranteed fit: ponds with a similar stepped lip profile
⚠ Likely compatible: most rigid plastic ponds with comparable edge thickness
❌ Not ideal for: thin liner-only ponds without a rigid edge

(If you know your exact pond model, compare these dimensions before printing for best results.)

Printing Recommendations

• Material:

  • PLA (easy, indoor use)

  • PETG (recommended for outdoor durability)

  • Nylon (best for long-term water + UV exposure)

• Orientation:

  • Print statue upright for best detail

  • Print clip flat for maximum strength in the ratchet teeth

• Layer Height: 0.16–0.2mm

• Infill: 15–25% (higher for clip strength)

• Supports: Required for statue overhangs

Assembly

1. Insert 10mm tube through the statue channel

2. Attach statue to clip base

3. Slide clip onto pond edge and tighten via ratchet

4. Connect tubing to pump and adjust flow

Notes

• Designed for aesthetic water flow, not high-pressure output

• Works best with small submersible pumps

• Slight scaling (±2–3%) may help fine-tune fit depending on your pond