Eibos Cyclopes Drier Fan Converter (minus a couple overhangs)

Two places were giving me trouble printing cleanly in PolyMax PC.

1. The rounded overhangs near the heater screw holes.  I suppose I could have just printed with supports, but I opted instead to extend the problematic overhangs down to the bed.  This sacrifices just a little fan cross section, but not much.
2. The bridging on the inside related to the wire channel wasn't bridging nicely, so I put a nicely-printable overhang there instead.

To be clear, I could have used the print of kcwu's model (maybe with a little scraping to clean up the screw holes), and kcwu's model does provide slightly more fan cross section.

I wish there were a way to attach a slightly-modified model to a “make”, since that's really all this is.