FENCY - the garden fence drink holder

FENCY - the garden fence drink holder
Suitable for garden fences with up to 30mm cross braces. 
(I added a XL version for up to 45mm cross braces and a smaller one for modern fences with 20mm) 

Prevents your drink from getting too warm due to your hands. Prevents your drink from spilling due to clumsiness while gardening.
The ultimate gardening tool.

Print instructions:

• fency_hook:
  • Print it lying on its side, so you don't need many supports
  • 0.3mm layer height
  • 3 perimeter
  • 30% infill
  • support: yes
  • Print without skirt 
     
• fency_ring:
  • Print it upper side down on the heat bed
  • 0.3mm layer height
  • 3 perimeter
  • 30% infill
  • support: no
  • Print without skirt 
     
• fency_bottom:
  • Print flat on the heat bed
  • 0.3mm layer height
  • 3 perimeter
  • 30% infill
  • support: no
  • Print without skirt 

Note: 

• Before assembling, the small bar on the fency_bottom part must be removed with a scalpel.

Info: 

• I used PRUSAMENT PETG for all parts. 
   
• For the fency_bottom part, i experimented with the Prusaslicer modifiers. In this case, i set the top and bottom layers of the tray to 0 and chose the honeycomb pattern as the infill.