Unifi UTR Thermal Spacer Plate (v2)

v3 now released, get it here. It has even more ventilation but needs supports when printing.

v3.1 also released for those of you who have a UGreen Nexode PB763/PB761 10000mah powerbank (as per one in the photos), get that custom one here.

This v2 model will be removed in the coming weeks as it's inferior........

This is v2 of the model. More ventilation ability but supports are required.

• Elevates UTR device by 3 mm to improve passive airflow and reduce heat build-up

• Ventilated underside design promotes air circulation (improved over v1)

• Helps maintain lower operating temperatures during sustained use

• Designed for use between travel routers / compact networking gear and power banks

• Lightweight, low-profile form factor adds cooling without bulk

• Precision-fit footprint for stable placement and reduced wobble

• Ideal for portable setups, travel rigs, and always-on devices

• Optimized for 3D printing with common materials (PLA, PETG, etc.)

• Simple, durable design with no assembly required, no supports required either.

Powerbank in photos is UGREEN Nexode Qi2 10,000mah, PB763 is the model number.

v2 (this model): I used PLA, the temperature readings I get on the UTR is 40.2°C on the screen. 41.1°C hottest spot on top, and 42.6°C max on the bottom when using the model.

v1: I used PLA, the temperature readings I get on the UTR is 42°C on the screen. 42.4°C hottest spot on top, and 45.6°C max on the bottom when using the model.

PETG would be ideal if your temps are too close to 50-60°C.

See newer models below.....