Patronus Stag — Ring Holder Bust

A stylized stag bust on a round pedestal — head and shoulders only,

antlers raised. Each antler has 4 thick tines angled upward at 50–75°

from horizontal so jewelry rings slide down the tine and rest at its

base. Built with chunky beams and no fragile spikes; the whole piece

prints solidly.

• 70 mm pedestal, ~120–140 mm tall depending on antler reach

• - Single solid, flat bottom — prints upright, NO supports

• - Holds a stack of rings on each tine; smaller rings slide further

• - Doubles as a desk decoration when not in use

Print notes:

• 0.2 mm layer, 15–20 % infill is plenty

• - Silk PLA looks great on the antlers (the photo is silk metallic blue)

• - Light stringing between antler tines is normal — quick wipe with a

•   hot-air gun cleans it up