Horror Bookmark Collection

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

There are six plates for the six characters. 

Plate 1: Billy from Saw, 

Plate 2: Freddy Krueger from Nightmare on Elm Street, 

Plate 3: Pennywise from It, 

Plate 4: Ghost Face from Scream, 

Plate 5: Pinhead from Hellraiser, and 

Plate 6: Jason from Friday the 13th.

Plates 1-4 have the same color swaps: Saw Billy, Freddy Krueger, Pennywise set, and Ghost Face.

Plate 5(Pinhead) has only 2 colors, however, I used Bambu Beige to give a different tone, but white is acceptable.

Plate 6(Jason Set) uses beige also, but white is acceptable also. 

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Swaps for plates 1-4: Billy from Saw, Freddy Krueger, Pennywise Set and Ghost Face
Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Blue Gray  Transmission Distance: 3
    PLA BambuLab Basic Red  Transmission Distance: 4
    PLA BambuLab Basic Jade White  Transmission Distance: 4.6
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer (0.88mm) swap to Blue Gray
    At layer (1.04mm) swap to Red
    At layer (1.36mm) swap to Black
    At layer (1.44mm) swap to Jade White for the rest.

 Swaps Pinhead plate 5:

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Beige  Transmission Distance: 8
This print uses 2 unique filaments

Swap Instructions:
    Start with Black
    At layer #10 (0.88mm) swap to Beige for the rest. 

Swaps for plate 6: Jason set

Filaments Used:
    PLA BambuLab Basic Black  Transmission Distance: 0.6
    PLA BambuLab Basic Beige  Transmission Distance: 8
    PLA BambuLab Basic Red  Transmission Distance: 4
This print uses 3 unique filaments

Swap Instructions:
    Start with Black
    At layer #10 (0.88mm) swap to Beige
    At layer #15 (1.28mm) swap to Black
    At layer #16 (1.36mm) swap to Red for the rest. 

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print. Stringing may occur with Hueforge, just use a lighter to whisk them away. 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections