Clay Target Trophy

This is a trophy I designed for skeet or trap shooting. V3 has a hole in it to fit a US silver dollar. V4 i just planned on getting a disk engraved to fit in the center of the trophy to display what the trophy was for, but you can do what ever with that i suppose.

Supports are 100% needed for V4 as the bottom of the target will print in thin air otherwise. V3 can print without supports, but i'd advise to use them, otherwise the back of the target could get a bit messy.

Print Settings

Printer Brand:

FlashForge

Printer:

Rafts:

No

Supports:

Resolution:

0.12mm

Infill:

Filament: Hatchbox PLA gold

Category: Decor