November 3, 2024
Description
This one is made specifically to match device's design.
Original request by wavapps :
https://www.thingiverse.com/thing:3465870/comments
Still, I recommend to print it at 0.15 mm of height. Or, don't go over 0.2, you'll lose accuracy for the clip. Not too fast either.
| Recommended settings | \_/ Ø 0.4 | |
| Layer height | 0.15 | |
| Perimeters | 2 | |
| Infill | 20% | |
| Bottom & Top | 5 | 5 |
| Supports |
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Zendama
