Umbreon Hueforge

Umbreon

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 94.4x150mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.56mm and the Actual Thickness is 2.24mm

    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #4c5f71 PLA BambuLab Basic Blue Gray  Transmission Distance: 3
    #8e9089 PLA BambuLab Gray  Transmission Distance: 2
    #fec600 PLA BambuLab Basic Sunflower Yellow  Transmission Distance: 4.4
    #ff6a13 PLA Bambulab Orange  Transmission Distance: 5.6
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 7 unique filaments

Swap Instructions:
    Start with Black
    At layer #6 (0.56mm) swap to Blue Gray
    At layer #10 (0.88mm) swap to Gray
    At layer #16 (1.36mm) swap to Sunflower Yellow
    At layer #18 (1.52mm) swap to Orange
    At layer #20 (1.68mm) swap to Red
    At layer #21 (1.76mm) swap to Jade White for the rest.