AirMaks Katran or Krait .22 /5.5mm Single Shot Loader

Very quick to print and easy to install Single Shot loader. It can easily take 40 grains slugs. 

This is made for .22 / 5.5 mm pellets or slugs. It nicely snaps into the gun as well as into the magazine holder.

There is no notch or alike to hold the pellet or slug in place, since the Pellet Probe has a diameter of ~5.8mm, therefor hold the air gun horizontal while loading otherwise it falls out. 

It nicely snaps into the gun as well as into the magazine holder. Note that when you want to take it out of the magazine holder, to not pull on the lever, as this will cause the lever to rotate and make it hard to pull out. In stead, grab the lever and pull it out AND towards the opposite side of the magazine holding recess in the gun. I guess it all makes sense once you got it printed. 

You will need a ~16mm small pin (approx 1.5mm in diameter. I used a smal piece of the pin of a rivet. 

NOTE: these are tight tolerances. All printers are different and all materials are different. Play around if yours does not fit. Mine was 100% perfect, printed on the CoreOne plus with Formfutura's Carbonfill CF03 PETG. 

Enjoy!