Cable Organizer — 5-Slot Desk Cord Holder | Snap-In, Adhesive Base, No Supports

The 30-minute print that fixes the most annoying thing on your desk.

You plug your phone in, let go, and the cable slithers off the edge. This little organizer ends that forever. It has five keyhole slots — push a cable through the narrow neck and it snaps into the round pocket and stays put. Pull it out when you need it; the next cable waits exactly where you left it.

The slots are different sizes on purpose so the holder grips thin and thick cables alike instead of one-size-fits-none.

### Features

- 🔌 5 cables, sorted — graduated slots Ø5 / 6 / 6 / 7 / 8 mm

- ✊ Snap-in retention — narrow necks hold cables in, no pop-outs

- 📌 Flat base for 3M / VHB tape — mount on desk top or under the edge

- ↔ Through-channels — cables seat fully, route either direction

- 🖨 No supports, prints in well under an hour

- 🎨 Looks clean in any color — great in matte black or a fun accent

### Perfect for

Desk & nightstand charging · USB-C / Lightning / micro-USB · headphone & aux cables · monitor / dock cables · office, gaming, and WFH setups · quick gift / giveaway print

### Mounting options

- 3M VHB / double-sided tape on the flat base (cleanest look)

- Set it on the desk — the body has enough mass to stay put with cables loaded

- Remix-friendly: ask for screw holes or a desk-edge clip version

---

## PRINT SETTINGS

- Material: PLA, PETG, or ABS — any works

- Layer height: 0.20 mm

- Walls / perimeters: 3

- Infill: 20 % (more = more desk-holding weight)

- **Supports:** None

- Orientation: As exported — flat base on the plate, slots opening up

- Print time: ~30–45 min · ~20 g

Fit tip: Cables vary. If a slot grips too tight or too loose for your favorite cable, scale the model ±2–3 % or pick a different slot — that's why the sizes are graduated.