Vase Mode Hex Corrugated Large Phone Holder W/Charging Slot!

This is my go-to phone holder. I have one in my office holding my work phone [iPhoneXR w/ OtterBox Commuter case pictured] as well as another on the dining table. It's great being able to comfortably see the phone in portrait mode while it's charging too!

Each holder prints in about 2.5 hours for me using only 20g of filament.

This model is designed for 0.4mm nozzle diameter prints. This is because the model has both an inner and outer vase “surface” with a gap that narrows to 0.5mm to allow the two “surfaces” to fuse for structural rigidity. The two “surfaces” are accomplished via a 0.1mm seam that runs the width of the stand and ends up purposely fusing during the print because the gap is so small.

• PLA
• vase mode / spiralized outer contour
• 0.4mm nozzle
• 0.2mm layer height
• 1mm base layer
• no supports