PHONE CHARGING STAND INCORPORATING IKEA LIVBOJ

Our Ikea Livboj chargers are scattered all over the house, and they take up a lot of desk real estate while rending the phone unreadable in it's horizontal position.

This is a simple print, needs no support, and the power cable to the charger runs internally in a curved duct which holds it quite firmly.  This in turn allows the cable to act in conjunction with the two side tabs to keep the charger secure and in position for contact with the telephone.

The side tabes simply locate the phone in the centre of the charge pad and should work with Apple and Android phones.

The original (smaller) version measures 75mm to the centre of the charger from the bottom of the case.   It has been tested with iPhones X to 13 Pro - but should work with most phonse less than 80mm wide with 65 - 75mm from the bottom of phone to centre of charge pad (75mm to centre).

The larger version is 80 mm to the centre of the charger and is designed for iPhone ProMax and Plus sized phones.  It's been tested with the ProMax only.

Pro Max ADAPTER - charging  with the standard version is not reliable for larger phones, so if you upgrade this adapter will raise the Livboj  charger by 5mm (80mm to centre of charger) which is the centre of the iPhone (with no case). 

The adapter is a firm press fit.  Hold on the charger and push it firmly into place.

Of course I'd recommend printing the larger version of the stand- but this should get you by until you do.

THICKER CASES - I've  uploaded a version to allow for cases up to 15mm thick on 28 November which had an error in it and the Charger won't fit.   I will have that repaired and re-uploaded shortly!