INDX Rear Filament Sensors Holder V2

V2 of my rear filament sensor holder for the SpacePi rack. I was not happy with the first design, as it was sticking out too much at the back of the printer. This design is much slimmer and does not stick out more than the filtration system

For installation you will need:

• 4x M3x6 screw

• 6x M3x10 screw

• 5x M3 nylon nuts

• PTFE tubes

On the screenshot you can see mounting points for top(1-4) and bottom(5-8) filament sensors

I also used Filament sensor Bowden adapter