April 27, 2022
Description
As you all know, ipods are the slipperiest devices on planet earth, and i liked icomputer7's bumper case. Thin, unobtrusive, but the back of it was prone to breaking off because of a weak point in the walls where they connect to the base, so i just added a fillet that fits within the radius of the ipod's curve. Also shortened the face a little so it didnt stick out so much. This case is intended for the "fat" 60Gb iPod.
Printer Brand:
Tiertime
Printer:
Up300
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
25%
Filament:
any PLA
Notes:
pretty simple design, might want to turn on thin wall support or lower the extrusion width so you get good strong thin walls.
License:
Creative Commons — Attribution
Spectura
