This modern design table legs with moderate strength and be practicable use. The leg were designed with heights of 100 and 200 mm. Need 3 screws for each leg.
100mm Leg require:
Recommended diagonal of the top board at least 210 mm.
Need 3 screws for each leg. The holes have a diameter of 3.3mm, the blind hole 6.6mm.
200mm Leg require:
Recommended diagonal of the top board at least 420 mm.
Need 3 screws for each leg. The holes have a diameter of 5.4mm, the blind hole 10.8mm.
Print Settings:
Material: PLA, PETG
Layer height: 0.3mm
Supports: No
Perimeters: 2 (Increase according to the required toughness.)
Infill: 15% (Increase according to the required toughness.)
Assembly:
Place the table legs on the diagonal of the board.
Temporarily tightening the screws near the center of the board.
Install the screws on the outside of the board and tighten the screws on the inside as well.
BaGooN
