Raspberry Pi Zero Stand, Stemmafied

A slightly maximalist remix of the awesomely simple Raspberry Pi stand by Adafruit, for those situations where you just need ALL THE THINGS. Or, like, more of them anyway.

Original: https://www.printables.com/model/7260-raspberry-pi-zero-stand

Additions include:

1. Pi Cam mount
   • Requires some M2 mounting hardware to mount the Pi Cam
   • Works with any Raspberry Pi Cam V1/V2 or layout-compatable clone boards
   • Slots included to keep the flat CSI cable out of the way
2. STEMMA-QT board or other M2/M2.5 board mounts
   1. Requires some M2 or M2.5 mounting hardware to mount boards
   2. Layed out in a neat 10mm x 12.5mm grid
3. Magnetic foot mounts
   1. Requires M3 nuts, 5mm M3 spacers, and M3-screw mag feet
   2. Magnetic feet: https://www.adafruit.com/product/4631
4. Rear pin-header slot
   1. Need to get at the header pins from the back? No problem! :D

Note: This was my first Fusion 360 project, so the F360 source file is a horrible mess. Apologies to the original author(s) for how heavily I butchered their original project file. 😂

Printing Notes

For FDM printers I recommend printing this one face-down with bed-only supports enabled. This makes for much more reliable mounting hole printing and the nicer surface finish doesn't hurt.

Test prints were done on a stock Prusa MINI+ with Prusament Clear PETG filament. Sliced with PrusaSlicer, 0.15mm QUALITY, flipped 185-degrees to print “face down”, with some minor cosmetic tweaks (hexagon infill, archimedian chord surface infill). Prints took about 4 to 4 and a half hours.