April 29, 2022
Description
*I've replaced all versions today(16 Jun 2018)* with V2 that has a taper, read more below**
This is a simple holder for 5 cartridges with a diameter of 12mm so it should fit most of the common ones for hunting like .30-06, 6.5-55 etc.
A couple different ones with different texts on them and a custom I made for my brothers hunting group, I've also included a blank one that you can modify and enter any text you want.
Formats included are.stl and .step
These are the available variations added so far
I got some feedback that the fitting wasn't as good as it could get so I redesigned the clip. It now tapers from 10.95mm to 12.05mm
Because of the taper I've also added the text "top" on one side where the narrow end is, simply put the pointy end this way and it should fit.
These are the various measurements that I have based the design on, if you want a custom one made just send me a message or make a comment. I know that some of the cartridges are a bit thicker(ie. Winchester, 6.5 etc.) but it's still within 0.5mm margin so better a bit snug then to loose!
Printer:
reprappro
Rafts:
No
Supports:
No
Notes:
Print it standin up and you won't need any supports etc. Depending on your printers calibration you can easily scale the model in your slicer.
If the shells are to loose, lower the scale by 1-2% and try again until you find your sweet spot!
Print in RAL 2010 color or any other dark/clear orange for following hunting guidelines.
Filling it!
Just start with the center slot before filling the outer four, otherwise it might be hard to get it into there!
Category: Sport & Outdoors
License:
Creative Commons — Attribution — Share Alike
11
Naesstrom
