April 29, 2022
Description
I wanted a holder for my ESP8266 dev board and some sensors within my stevenson screen so I made a simple mesh holder with plenty of room!
Printer:
RepRapPro Mendel
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0,2
Infill:
30
Notes:
I didn't need any supports since the distance is just 2mm you should be fine without them
Mounting sensors and board
I used small zip ties to mount my board and sensors to the mesh, the design is a bit smaller then the hole in the stevenson screen so I was able to nudge it in there.
Just remember to put the usb contact facing downwards if you are powering it with that.License:
Creative Commons — Attribution
9
Naesstrom
