Rockler Dust Right to 4" Powertec Reducer adapter

Someone I know had a Powertec 4" to 2 1/2" reducer that was too small to fit in their Rockler Dust Right Quick Change handle. Both are "4 inches" but there is a roughly 7mm difference in I.D. and O.D. of the two products.

It should be printed in TPU.

There is 40mm of room to work with on the Dust Right handle but I found a 16mm wide band was plenty to get a good tight fit. It can be scaled on the Z-axis of your slicer if you want to make it wider. I tested one at 32mm wide and it was VERY hard to pull the reducer out after fitting them together.

Print Settings

Rafts:

No

Supports:

Resolution:

.28

Infill:

Filament: Yoyi TPU Red

Category: Parts