Ord Bot Hadron BLTouch Mount

This is a mount that I created to attach the BLTouch probing sensor to my Ord Bot Hadron with Bulldog XL extruder and E3D V6 hot end. It attaches to the back side of the X-Carriage using M2.5 screws through the standard mounting holes on the back side of the plate. The BLTouch probe works great and was very easy to set-up connecting to RAMBo board's MX1 header and Z-min endstop.

Post-Printing

Clean up holes and mount BLTouch with wires facing away from X-Carriage. Route wires across the top and through mounting bracket to go underneath X-Carriage plate and back up through large hole on the bottom side of the plate.

Video

A little video demo off the BLTouch in Action on my Ord Bot Hadron Mount.

Category: 3D Printer Accessories