EVA dual 5015 E3D Volcano back plate

This is mod of Supersniffles/JustaNormalGuy's dual 5015 EVA back plate to support an E3D Volcano hotend.

The Volcano's nozzle sits some 8.5mm lower than a normal V6 so this backplate has the fan outlet ducts moved down by that amount.

Also included is a matching MGN12 bottom that uses an M3, 4mm deep, 5mm diameter heatset insert to receive the V6 support part screw.

The EVA ducts do not need changing from the original design.

Note: You may have to trim ~10mm off the top of the rear leadscrew to clear the back of the duct when at X/2, Y max. This bit of the screw is not used but please check before firing up your Dremel!

Print Settings

Filament: Any ABS or ASA.

Category: 3D Printer Parts