April 30, 2022
Description
I ended up using a normal microswitch for my X Endstop (only two wires needed in the umbilical) and the stock endstop block was a bit too low.
This is a slightly (3mm) taller version and whilst at it, I increased the width & thickness of the slot to permit the use of a washer and make it less susceptible to deforming.
Printer Brand:
LulzBot
Printer:
TAZ 6
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20% Triangle
Filament: Any Any (except TPU!). Any How I Designed This ===================
Category: 3D Printer PartsLicense:
Creative Commons — Attribution
7
Ruffle
