Hultarp Magnetic Rack Mount for Skadis

Mount IKEA's magnetic Hultarp knife rack to the Skadis pegboard.

No extra hardware needed, just a flat head screwdriver to twist in the pins.

Print one of each pin. The orientation of each corresponds to the holes in the Hultarp's bracket.

The mid-support is optional but recommended. It keeps the bracket in place and also takes some of the weight off the pins, especially when held to the bracket with double-sided adhesive tape.

For best results:

• Use a layer height of 0.12mm or lower on all pieces.
• Print the pins with 100% concentric infill or increase the number of perimeters/walls. The mid-support can be printed with minimal infill.
• Use supports on all pieces. Ensure all support material is fully removed and cleaned up.
• Apply forward pressure when twisting the pins in place to avoid snapping.
• Use a filament with a bit off flex, like PETG. PLA works fine but can snap.

Note: The holes in the Hultarp bracket line up perfectly with the Skadis, so you could also attach it with some M4 bolts and washers. The mid-support would still be useful in this case.