Dagoma NEVA XL spool holder arm

I liked the Dagoma Neva spool support by Achrome that I found on Thing I verse and I likes the spool holder clip by Phende, so thought I would give them a try. Turns out that most of my filament comes in reels that are much wider than the what the spool holder arm was designed for, so I did a remix of the reel arm to make it long enough for any reel of filament. Also the little locking swivel pin on the support arm is not the way I would do things. I would put the locking pin or this case make it a locking cam on the top of the support arm and put a mating slot on the top of the main clip. But what I did was put in my longer support arm and just make a mark on the arm that lined up with the keyway on the main body clip. Then just drilled a small hole and put in a finnish nail as the locking pin, all near the top.

Thanks guys for this design as it has made the printer foot print much smaller and easy to move around.

Print Settings

Printer Brand:

DAGOMA

Printer:

Rafts:

No

Supports:

Resolution:

.2

Infill:

Notes:

what I did was put in my longer support arm and just make a mark on the arm that lined up with the keyway on the main body clip. Then just drilled a small hole and put in a finnish nail as the locking pin, all near the top.

Thanks guys for this design as it has made the printer foot print much smaller and easy to move around.

Category: 3D Printer Accessories