Topsflo TS5 under table mount

This is a design to hold the Topsflo TS5 pump commonly used in homebrewing under a table.

V1 design:

Fits the earlier revision with a notched design, this will work if your not pumping hot liquids, t

V2 design:

was for a newer revision of the pump without the notch pattern where the impeller housing

V3 design:

Should fit both revisions of pump but crucially can be clamped down harder on the pump, this is nessary if the pump is carrying liquids near boiling point, previous designs with PETG tended to warp and fail to grip the pump.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.16

Infill:

Filament: Generic PETG PETG White

Notes:

Category: Kitchen & Dining