May 4, 2022
Description
I made this so it fits without requiring any screws. Once printed, you can use wood glue or even two-way tape to secure it in.
It's made for a desk height of 15cm.
Printer Brand:
Creality
Printer:
Ender 2
Rafts:
No
Supports:
No
Resolution:
0.1
Infill:
100
Filament: Wanhao PLA Natural White
Notes:
I printed this on its side to eliminate needing supports.
How I made this thing?
A corner is a corner, especially a desk has a very sharp corner. I designed this to "mimic" the corner of a desk while also providing a safety feature.
Using Blender:I added a cube and measured 15cm to get my desk height.
Then I added second cube and placed it over the first cube and began stretching it out until I had my basic shape of the guard.
I turned the first cube at 90 degrees so as one of it's corners was in the middle of the second cube.
Next, I added two more cubes and placed them on the corners of the second cube and rotated one at 45 degrees and the other at -45 degrees.
Using the Boolean modifier, I selected "Intersect" and made a clean cut of the two angled cubes.
I then added another boolean modifier and cut the mid section of the second cube using the first cubes dimensions.
At this point I had a basic "C" shape.
Jumped into Edge mode and selected an edge and pressed "Ctrl + B" to bevel out the edges to make them round.
That was how i made this thing.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
9
Ecks-calibur
