May 5, 2022
Description
A simple rear shelf designed to fit the BrainFPV GPS module. Will also fit the uBlox M8 GPS and most other drone-sized modules.
Tip: In addition to VHB tape, use a heat gun to warm up the tabs and then form them against or over the edges of the GPS module for a very secure fit.
There is a gap in the shelf supports that allows you to attach a small module such as a receiver or Vifly Finder/Beacon using VHB and a zip tie.
Printer:
Flux Delta
Rafts:
No
Supports:
Yes
Resolution:
0.18
Infill:
No, 5 outer wall rings.
Filament:
AmazonBasics PLABlack
Notes:
You'll be printing on supports no matter what, so align the print plane to the camera base plate or to aircraft level.
License:
Creative Commons — Attribution
8
tiz.io
